Direct answer:TR CU 010/2011 covers machinery and/or equipment within its scope placed on the Union market. Mandatory assessment and certification versus declaration depend mainly on product identification and Annex 3 lists. Check other applicable regulations too. Trade names, HS codes or the broad category “machinery” alone cannot determine the outcome.

Safety of Machinery and Equipment was adopted by Customs Union Commission Decision No. 823 of 18 October 2011. EEC publishes the regulation; projects must check the current amended text and relevant lists.

Scope: Identify Equipment Before Checking Regulations

The regulation establishes minimum safety requirements for design, manufacture, installation, commissioning, operation, storage, transport, sale and disposal. Article 1 covers machinery and equipment with identified hazards for which Annexes 1 and 2 prescribe elimination or reduction measures.

The regulation also specifies exclusions and special provisions. Used equipment, equipment manufactured for the manufacturer's own use, and repair/maintenance components and spare parts are outside its mandatory conformity-confirmation requirements. Certain special equipment is excluded or governed elsewhere. Verify Article 1 and product facts; these examples are not a complete exclusion list.

Agricultural and forestry tractors and their trailers are expressly excluded, but machinery mounted on them may remain covered. Equipment at hazardous production facilities is not exempt merely because of its operating setting.

Certificate or Declaration: Check Annex 3 Product Lists

TR CU 010/2011 provides certification by a body in the Union unified register or an applicant's declaration under prescribed rules. Annex 3 lists each category. Where permitted, applicants may choose certification for declaration-listed products under the relevant scheme; this does not allow unrestricted substitution.

Certificates and declarations have equal legal effect under this regulation across the Union unified customs territory as prescribed. Market placement also requires every other applicable technical regulation. A TR CU 010/2011 document does not automatically cover low voltage, electromagnetic compatibility, pressure equipment, explosive atmospheres or specific product rules.

Suggested Assessment Sequence

  1. Compile precise equipment names, use, operating principles, parameters, composition and model families; prepare photographs, drawings, technical descriptions and instructions.
  2. Check Article 1 definitions, scope and each exclusion; identify whether components are independently regulated products where necessary.
  3. Match the product against Annex 3 certification or declaration lists and check supplementary safety provisions and other applicable regulations.
  4. Determine series production, batch or single-unit supply, assessment scheme and eligible applicant. Applicants generally must be legal entities or sole proprietors registered in an EAEU member state and meet the scheme's role requirements.
  5. Prepare safety justification, technical specifications where available, operating documents, standards information, test/research evidence, supply contracts or accompanying documents for batches/single units, and other applicable evidence. Confirm the final list by product and scheme.
  6. Complete required testing, document review and certification or declaration; verify registration, model and supply coverage, then use the EAC mark once conditions are met.

Common Misunderstandings and Limitations

  • Misunderstanding: All Machinery Uses the Same Certification.Regulatory lists distinguish certification from declarations; specialised products may have specific regulations.
  • Misunderstanding: EU CE Certification Establishes TR CU 010/2011 Compliance.Foreign tests or certificates may inform technical evidence but do not replace Union assessment procedures and documents.
  • Misunderstanding: Every Model in a Series Is Automatically Covered by One Document.Model coverage and technical differences must be checked against the application scheme and by the assessment body using supporting documents.
  • Misunderstanding: Passing Assessment Ends All Responsibilities.Manufacturers and relevant operators retain obligations for continued conformity, technical documentation and markings.

This article provides regulatory navigation, not an assessment decision for specific equipment. Confirm assessment forms, applicants and testing using complete product information.

Official Basis

Official sources reviewed: 13 November 2026. Refer to the current EEC directory and officially published texts. Recheck this interpretation following amendments.

Explore Machinery Service ScopeDiscuss Your Product